Using 2x4basics AnySize Chair or Bench Ends Sand and your 2x4's you can custom build a very sturdy bench chair or loveseat up to 6 feet (1.8 m). Simple assembly with only a powered screwdriver and a saw. Only straight 90 degree cuts are required - no miters or angles. All hardware is included. Ergonomic design makes the assembled seat surprisingly comfortable. Each 2x4basics AnySize Chair or Bench Ends includes an integrated cup holder. Made of durable and maintenance free structural resin the all-weather frame is built to last. The assembled unit stands 32 inches (813 mm) to the top of the back with a 17 inch (432 mm) seat height. You choose the length. Sand in color. Combine the AnySize Chair or Bench Ends with the Outdoor Dining Table AnySize Table Picnic Table Set or Flip Top BenchTable to create functional and attractive outdoor furniture groupings.

• Build your own bench loveseat or chair any size up to 6 feet using our AnySize Chair or Bench Ends kit and your 2x4's


• Assembly is simple.


• Made of durable maintenance free structural resin


• Includes 2 bench end supports hardware and assembly instructions (lumber not included)


• Lifetime warranty

More detail ...

worked well

I needed two ten foot benches to fill an area on my patio. I purchased 3 sets of bench ends and used 3 bench ends per bench 1 on each end and 1 in the middle. It worked really well. The product specifies to use 2 x 4's for bench seat back and supports but I used 5/4" cedar decking for the seat and back and used 2 x 4's for the supports. This is a very reasonable cost way to have a lot of seating.More detail ...

Good idea good product

I just finished assembling a 2x4basics AnySize Bench 11200 and am very happy with it. The bench assembly took a little longer than I thought it would. I think I worked on it for about two hours. I wasn't counting on having to drill pilot holes for the dozens of screws (included) that had to be used putting the bench together. Nor did I figure on spending so much time figuring out how to best sink the screws into the underside of the boards. Don't worry about slanting the screws into the wood a bit. It is impossible to get a drill into a perfect position for making a 90 degree hole. Most of the screws do not show anyhow.



It was necessary to tip the bench over in order drill pilot holes and to get at the screws. I had to clamp the 2x4's to the plastic/composite ends to keep them from falling off or moving out of position. I would recommend using a couple of small carpentry clamps to hold things in place while putting the bench together.



I had the 2x4's sanded and painted prior to attaching them to the plastic/composite ends so that took a little time but probably not more than an additional hour. That probably saved time in the long run. Making this bench with the 2x4 basics kit is not a difficult project.



The 2x4 basics bench is solid and not all that heavy but it isn't going to blow over in a high wind. I am quite satisfied with how the bench came out and somewhat surprised at how substantial it is. I thought it might twist and perhaps wiggle side to side--nope it is a rock.



I am so pleased with this approach to building patio furniture that I will be recommending the product to friends.

More detail ...